RESUMO
Total adenosine triphosphate (tATP) was investigated for its potential as a rapid indicator of cyanobacterial growth and algaecide effectiveness. tATP and other common bloom monitoring parameters were measured over the growth cycles of cyanobacteria and green algae in laboratory cultures and examined at a drinking water source during an active bloom. Strong correlations (R2>0.78) were observed between tATP and chlorophyll-a in cyanobacteria cultures. tATP offered greater sensitivity by increasing two orders of magnitude approximately 7 d before changes in chlorophyll-a or optical density were observed in Lyngbya sp. and Dolichospermum sp. cultures. Increases in tATP per cell coincided with the onset of exponential growth phases in lab cultures and increase in cell abundance in field samples, suggesting that ATP/cell is a sensitive indicator that may be used to identify the development of blooms. Bench-scale trials using samples harvested during a bloom showed that tATP exhibited a clear dose-response during copper sulfate (CuSO4) and hydrogen peroxide (H2O2) treatment compared to chlorophyll-a and cell counts, indicating that cellular production and storage of ATP decreases even when live and dead cells cannot be distinguished. During Copper (Cu) algaecide application at a reservoir used as a drinking water source, tATP and cell counts decreased following initial algaecide application; however, the bloom rebounded within 10 d showing that the Cu algaecide only has limited effectiveness. In this case, tATP was a sensitive indicator to bloom rebounding after algaecide treatments and correlated positively with cell counts (R2=0.7). These results support the use of tATP as a valuable complementary bloom monitoring tool for drinking water utilities to implement during the monitoring and treatment of cyanobacterial blooms.
RESUMO
Standardization and validation of alternative cell lysis methods used for quantifying total cyanotoxins is needed to improve laboratory response time goals for total cyanotoxin analysis. In this study, five cell lysis methods (i.e., probe sonication, microwave, freeze-thaw, chemical lysis with Abraxis QuikLyseTM, and chemical lysis with copper sulfate) were assessed using laboratory-cultured Microcystis aeruginosa (M. aeruginosa) cells. Methods were evaluated for destruction of cells (as determined by optical density of the sample) and recovery of total microcystin-LR (MC-LR) using three M. aeruginosa cell densities (i.e., 1 × 105 cells/mL (low-density), 1 × 106 cells/mL (medium-density), and 1 × 107 cells/mL (high-density)). Of the physical lysis methods, both freeze-thaw (1 to 5 cycles) and pulsed probe sonication (2 to 10 min) resulted in >80% destruction of cells and consistent (>80%) release and recovery of intracellular MC-LR. Microwave (3 to 5 min) did not demonstrate the same decrease in optical density (<50%), although it provided effective release and recovery of >80% intracellular MC-LR. Abraxis QuikLyseTM was similarly effective for intracellular MC-LR recovery across the different M. aeruginosa cell densities. Copper sulfate (up to 500 mg/L Cu2+) did not lyse cells nor release intracellular MC-LR within 20 min. None of the methods appeared to cause degradation of MC-LR. Probe sonication, microwave, and Abraxis QuikLyseTM served as rapid lysis methods (within minutes) with varying associated costs, while freeze-thaw provided a viable, low-cost alternative if time permits.
